Intermec 1470 User Guide
1470/1471 Imager User’s Manual
3-68
6. Enter the length of the code for the alternate format and click Next.
7. Choose Alternate 1, Alternate 2, or Alternate 3 and click Next.
8. Click Select Command, choose a command and enter any required information,
click OK, and click Finish.
9. Click OK.
10. Click the Write Settings to Device button (
).
To initiate alternate data formats using bar codes
• Scan one of the following bar codes.
Alternate Data Format 1
Alternate Data Format 2
Alternate Data Format 3
Output Sequence Overview
When you turn off Required Output Sequence, the bar code data will be output to the
host as the imager decodes it. When you turn on Required Output Sequence, all output
data must conform to an edited sequence or the imager will not transmit the output data
to the host device.
host as the imager decodes it. When you turn on Required Output Sequence, all output
data must conform to an edited sequence or the imager will not transmit the output data
to the host device.
Note:
This selection is unavailable when the Multiple Bar Codes Selection is turned on.
Output Sequence Editor allows you to program the imager to output data (when
scanning more than one bar code) in whatever order your application requires,
regardless of the order in which the bar codes are scanned. Reading the Default
Sequence bar code programs the imager to the Universal values, shown below. These
are the defaults. Be certain you want to delete or clear all formats before you read the
Default Sequence bar code.
scanning more than one bar code) in whatever order your application requires,
regardless of the order in which the bar codes are scanned. Reading the Default
Sequence bar code programs the imager to the Universal values, shown below. These
are the defaults. Be certain you want to delete or clear all formats before you read the
Default Sequence bar code.