Intermec 1470 User Guide
Programming the 147X
3-75
3
Or scan one of the following bar codes. The default setting is marked with an asterisk
(*).
(*).
On
Off
*
If you want a different notation than “NR,” for example, “Error” or “Bad Code,” you
can edit the output message using the Data Formatter. The hex code for the No Read bar
code is 9C.
can edit the output message using the Data Formatter. The hex code for the No Read bar
code is 9C.
Print Weight
Print Weight is used to adjust the way the imager reads Matrix bar codes. If an imager
will be seeing consistently heavily printed matrix bar codes, then a print weight of 6
may improve the reading performance. For consistently light printing, a print weight of
2 may help. A value from 0 to 7 may be used to adjust the print weight.
will be seeing consistently heavily printed matrix bar codes, then a print weight of 6
may improve the reading performance. For consistently light printing, a print weight of
2 may help. A value from 0 to 7 may be used to adjust the print weight.
In the Output Sequence tab of Visual Menu, enter a number from 0 to 7 in the Print
Weight entry field. Click the Write Settings to Device button (
) to send the new
settings to the imager.
Or scan one of the following bar codes. The default print weight is 4.
Set Print Weight (see Note)
Default
*
Note:
A one digit number from 1 to 7 is required after reading this programming bar
code. Refer to the “General Programming Chart” in Appendix B.