Intermec 1470 User Guide
Using QuickView
5-17
5
Build Command Bar Code Use to create an Aztec code from a command or set of
commands entered in the Serial Window. (The size of the Aztec code can be altered
using the File - Preferences selection.) You can then print out this bar code to program
other imagers.
commands entered in the Serial Window. (The size of the Aztec code can be altered
using the File - Preferences selection.) You can then print out this bar code to program
other imagers.
Build Clone Bar Code Use to capture the settings from one imager and to input them to
another imager. When the Build Clone Bar Code button is clicked, QuickView captures
the settings from the attached imager and creates an Aztec code that can be printed.
(The size of the Aztec code can be altered using the File - Preferences selection.) Any
imager that scans the resulting clone bar code will be programmed to the same settings
as the original imager.
another imager. When the Build Clone Bar Code button is clicked, QuickView captures
the settings from the attached imager and creates an Aztec code that can be printed.
(The size of the Aztec code can be altered using the File - Preferences selection.) Any
imager that scans the resulting clone bar code will be programmed to the same settings
as the original imager.
Serial Programming Commands
Note:
In the following table, an asterisk (*) indicates the default setting.
Selection
Setting
Serial Command
Factory Default Settings Show
DEFALT.
Status Check
Software Revision
REV?.
Default Show Data Formats
DFMBK3?.
Enable All Symbologies
ALLENA1.
Disable All Symbologies
ALLENA0.
Output Selections
Power PC Revision
REVMPC.
Boot Code Revision
REV_BT.
Terminal ID
TERMID.
Keyboard Country
KBDCTY.
Regular
KBDSTY0.
Caps Lock
KBDSTY1.
Shift Lock
KBDSTY2.
Emulate External Keyboard
KBDSTY5.
Keyboard Style
Automatic Caps Lock
KBDSTY6.