Intermec 1470 User Guide

1. Scan the Clear One Data Format bar code. This deletes one data format for one

symbology. If you are clearing the primary format, scan 0. If you are clearing an
alternate format, scan 1, 2, or 3, depending on the alternate format you are clearing.

Clear One Data Format

2. Scan the Terminal Type, Code I.D., and the length of the format you want to delete.

To find your terminal type, see the “Supported Terminals Chart” earlier in this
chapter. The length of the data format for that symbology is deleted and all other
formats are unaffected.

3. Scan Save or Discard.

Save Discard

This section explains the following commands:

• Send commands
• Move commands
• Search commands
• Miscellaneous commands

F1

Send all characters followed by “xx” key or function code, starting from current
cursor position.  Syntax = 

F1

xx

 (where xx stands for the hex value for an ASCII

code, see “Decimal to Hex to ASCII Conversion Chart” earlier in this chapter).

F2

Send “nn” characters followed by “xx” key or function code, starting from current
cursor position.  Syntax = 

F2

nnxx 

(where nn stands for the numeric value [00-99]

for the number of characters and xx stands for the hex value for an ASCII code;
see “Decimal to Hex to ASCII Conversion Chart” earlier in this chapter).