Intermec 1470 User Guide

Power Saving mode provides control of the imager’s power consumption as follows:

• Low Power draws low (50%) LED current during image capture, allowing only one

read attempt for each trigger pull. The imager is less tolerant of hand movement
during the read attempt and powers down after the image capture is complete.

• Medium Power draws a normal LED current during image capture, which enhances

motion tolerance. Medium Power attempts to read as long as the trigger is pulled,
going into a “doze” (low power) state after each read attempt. The imager powers
down 10 seconds after the image capture is complete.

• Normal Power draws a normal LED current, attempting to read as long as the

trigger is pulled or a decode is in process. The imager doesn’t go into a “doze” state
after each read attempt but may power down after 2 minutes if Power Hold Mode is
turned Off.

In the Imager tab of Visual Menu, choose Low, Medium, or Normal. Click the Write

Settings to Device button (

) to send the new setting to the imager.

Or scan one of the following bar codes. The default setting is marked with an asterisk
(*).

Low Power

Medium Power

Normal Power