Intermec SR60 Reference Guide
Chapter 4 — Enabling and Configuring Symbologies
124
SR60 Scanner Programmer’s Reference Manual
Label Length Format
The next two sections let you set the Standard 2 of 5/IATA label
length format to either Variable Length or Fixed Length format.
length format to either Variable Length or Fixed Length format.
Variable Length Format
You can set the Standard 2 of 5/IATA symbology to read Variable
Length Format.
Length Format.
To set Standard 2 of 5/IATA symbology to read Variable Length Format
1
Identify the minimum length setting you want to make. The
selectable range is 02 to 50 characters.
selectable range is 02 to 50 characters.
2
Scan the SET bar code.
3
Scan the Enable Variable Length Format bar code.
4
Scan the Set Minimum Label Length bar code.
5
Using the Digits bar codes on page 127, scan the digits to set
the minimum label length you identified in Step 1.
the minimum label length you identified in Step 1.
6
Scan the END bar code.
Note: For this symbology, the scanner decodes up to 50
characters, but the actual length read varies depending upon the
interface type, bar code physical size, and print quality.
characters, but the actual length read varies depending upon the
interface type, bar code physical size, and print quality.
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
digit first and then the length digit (such as 04, 06, or 08).
Variable Length Format
SET-------------------------------------
Enable Variable Length
Format
---------
Set Minimum Label
Length
---------