Intermec SR60 Reference Guide

When enabled, Low Power mode causes the scanner to power 
down completely between trigger pulls. This results in very low 
idle current, lowering the energy needs of the scanner. However, 
the microcontroller must reboot with every trigger pull, which 
causes a very small delay in scanning. Intermec recommends that 
you use this mode only when the scanner is connected to a 
battery-powered terminal.

Note: This feature is not affected when you restore the 

 

factory defaults by scanning the Return to Factory Defaults 
programming bar code. You must manually enable or disable 

 

this feature. 

Note: Low Power mode is not supported by the USB interface.