Intermec SR60 Reference Guide
Chapter 3 — Configuring Label Transmit Settings
50
SR60 Scanner Programmer’s Reference Manual
6
Scan the END bar code.
You have added a two-character prefix to all bar code data,
regardless of label symbology. The prefix will be added to the
label data before it is sent to the host.
regardless of label symbology. The prefix will be added to the
label data before it is sent to the host.
Setting Global Suffixes
You may add one or two suffix characters to the standard label
format. To add more than two suffix characters, contact Intermec
Product Support for Full Label Edit (FLE) options.
format. To add more than two suffix characters, contact Intermec
Product Support for Full Label Edit (FLE) options.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
Setting Global Prefix(es)
SET-------------------------------------
Set Prefix
---------
Use the ASCII chart on 68 to identify the ASCII character(s) and
the corresponding hex code(s) for the prefix. Then use the bar
codes on page 160 to scan the four digits corresponding to the hex
values.
the corresponding hex code(s) for the prefix. Then use the bar
codes on page 160 to scan the four digits corresponding to the hex
values.
END------------------------------------