Intermec 4800 User Guide

The standard interface cable is attached to the imager with an 10-pin modular 
connector.  When properly seated, the connector is held in the IT4600/4800 
imager’s handle by a flexible retention tab.  The interface cable is designed to be 
field replaceable.

•

Order replacement cables from IT4600/4800 or from an authorized distributor.

•

When ordering a replacement cable, specify the cable part number of the 
original interface cable.

1. Turn the power to the host system 

OFF.

2. Disconnect the imager’s cable from 

the terminal or computer.

3. Locate the small hole on the side of 

the imager’s handle.  This is the cable 
release.

4. Straighten one end of a paper clip.

5. Insert the end of the paper clip into the 

small hole and press in.  This 
depresses the retention tab, releasing 
the connector.  Pull the connector out 
while maintaining pressure on the 
paper clip, then remove the paper clip.

6. Replace with the new cable.  

Insert the connector into the opening 
and press firmly.  The connector is 
keyed to go in only one way, and will click into place.