Intermec 4800 User Guide

Note: The wildcard for all terminal types is 099.

, find the symbology to which you want to apply the data 

format.  Locate the Hex value for that symbology and scan the 2 digit 
hex value from the 

 inside the back cover of this 

manual.

Specify what length (up to 9999 characters) of data will be acceptable 
for this symbology.  Scan the four digit data length from the 

 inside the back cover of this manual.  (Note: 50 characters is 

entered as 0050.  9999 is a universal number, indicating all lengths.) 

that represent the command you want to enter.  94 alphanumeric char-
acters may be entered for each symbology data format.

Step 7. Scan Save from the 

manual to save your entries.

•

Clear One Data Format 
This deletes one data format for one symbology.   If you are clearing the 
primary format, scan 0 from the 

 inside the back cover of 

this manual.  If you are clearing an alternate format, scan 1, 2, or 3, depending 
on the alternate format you are clearing.  Scan the Terminal Type  and Code 
I.D. (see 

 on page 2-2), and the bar code data length for 

the specific data format that you want to delete.  All other formats remain 
unaffected.

•

Save from the 

 inside the back cover of this manual

This exits, saving any Data Format changes.

•

Discard from the 

This exits without saving any Data Format changes.

F1 Send all characters followed by “xx” key or function code, starting from cur-

rent cursor position.  

Syntax = F1xx (xx stands for the hex value for an 

F2 Send “nn” characters followed by “xx” key or function code, starting from 

current cursor position.  

Syntax = F2nnxx (nn stands for the numeric value 

(00-99) for the number of characters and xx stands for the hex value for an 
ASCII code.  See 

F3 Send up to but not including “ss” character (Search and Send) starting from 

current cursor position, leaving cursor pointing to “ss” character followed by 
“xx” key or function code.  

Syntax = F3ssxx (ss and xx both stand for the