Intermec 4800 User Guide

All communication parameters between the imager and terminal must match for 
correct data transfer through the serial port using RS-232 protocol.

RS-232 programmable selections are used by both the primary and secondary 
interfaces.  Changing an RS-232 parameter (e.g., baud rate or parity), while in 
primary 

or secondary mode will affect both interfaces.  If you want to change the 

RS-232 settings, refer to 

In Wand Emulation mode, the imager decodes the bar code then sends data in 
the same format as a wand imager.  The Code 39 Format converts all 
symbologies to Code 39.  The Same Code Format transmits UPC, EAN, Code 
128 and Interleaved 2 of 5 without any changes, but converts all other 
symbologies to Code 39.  These codes set the transmission rate to 25 inches per 
second and the output polarity to black, high.  

Default = Code 39 Format.  

The 

Code 39 Format bar code below sets the terminal ID to 61, and the Same 

Code Format bar code sets the terminal ID to 64.

RS-232 Interface

Wand Emulation

Code 39 Format

Wand Emulation

Same Code Format