Oregon Scientific mp 100 User Manual

CHARGING THE BATTERY

Before using your player for the first time, you should first charge the
battery by connecting your player to the computer using the supplied
USB cable. " READY" will show on your player's LCD screen when a
successful connection has been made.

NOTE: Charging only begins after the computer has been turned on.

When the battery is fully charged, the battery icon shows

and will

blink slowly. The battery status indicators are as follows:

NOTE: When the battery icon shows

, this indicates the battery is

about to run out of power within a few minutes. Recharge the battery
as soon as possible.

FILE TRANSFER

After connecting your MP3 player to the computer, the computer will
detect and identify the device as a removable storage drive, allowing
you to drag and drop files between your computer and your player.

Your player supports the following audio file formats for playback:

•

MP3 (MPEG-1, Audio Layer 3)

•

WMA (Windows Media Audio)

NOTE: Your MP3 player is equipped for mass data storage support.
This means that it can also be used as a portable hard drive to store
and transport all forms of computer data files. You will not be able to
view or play any of the stored data unless it is one of the supported
audio formats.

CAUTION: To prevent data loss before unplugging your player from
the computer, wait at least 15 seconds to make sure the file transfer is
complete.

Low

Medium

Full

03(QJU

5/18/04, 2:11 PM