Bosch hdi7132u User Guide

Page of 56
Getting Started
English 10
The locating pins on the outside edges of the cooktop fit into notches on the bot-
tom of the grates.
Burner grates should rest flat on the cooktop. When properly positioned, the 
grates will be level and will not move back and forth.
Electronic Ignitor
The cooktop uses electronic ignitors to light the burners, There is no pilot light. 
Each burner has its own ignitor. For proper operation, keep the ignitor clean and 
dry. It is necessary to clean these when there is a boilover or when the burner 
does not light even though the ignitor clicks.
CAUTION:
 
All ignitors spark when any single burner is turned on. Do not touch 
any of the burners when the cooktop is in use.
High Power Burner
The high power burner is the largest burner. It is the most powerful burner on the 
cooktop. It retains heat longer than normal burner caps and, at low settings, pro-
hibits the flame from touching the cookware. This results in a gentle, more pre-
dictable heat. Use the low settings on this burner to simmer large amounts of 
sauces or soups. Use the high settings to quickly bring large amounts of water to 
a boil.
Precision Burner
The precision burner is the smallest burner on the cooktop. It is well suited for 
gentle cooking of small amounts of food. Use the burner to melt butter or choco-
late or to  prepare delicate sauces.
Oven Racks 
Depending on model, the range is equipped with one of the following combina-
tions:
Two flat racks and one full extension rack
Two flat racks and one half rack 
Flat Oven Racks
The racks are designed with a stop so they will stop before coming completely 
out of the oven and not tilt. 
CAUTION:
To avoid burns, place oven racks in desired positions before turning 
oven on. Always use oven mitts when the oven is warm. If a rack 
must be moved while the oven is hot, do not let oven mitts contact 
hot elements.
Inserting Racks Into Oven
1.
Grasp rack firmly on both sides. 
2.
Tilt rack up to allow stop into rack guide. 
 Figure 7: Grates for Slide-in Models - Locating Pins