KYOCERA FS-C5015N Operating Guide

The printer is equipped with both parallel (FS-C5030N) and USB 
interfaces. Optional serial interface board kit and network interface card 
can also be installed. Various printing environment parameters such as the 
default emulation can be changed independently on different interfaces by 
using the printer’s menu selection system. Select the interface to apply the 
changes in the procedure described below.

This interface selection described below does not select the 

interface from which data will be received. The printer automatically 
selects the interface

The parallel interface supports a bi-directional/high-speed mode according 
to IEEE standards. Normally, this interface is used under the default setting 
Auto

. For details, see Parallel Interface (FS-C5030N only) on page 4-3. 

After setting the interface, be sure to reset the printer or turn the power off 
at least once. The new setting will be enabled thereafter. You can select 
from the following:

•

Auto (default)

•

Nibble/high speed

•

High speed 

•

Normal

Press [MENU].

Press 

U or V repeatedly until Interface > appears. 

If the interface is other than parallel, press 
[OK] ([ENTER]). A blinking question mark 
(?) appears.

Press 

U or V repeatedly until Parallel 

appears.

Press [OK] ([ENTER]) again. The question mark disappears.

To change the parallel interface mode, press 

Z. The current 

communication mode appears.

To change the communication mode, press 
[OK] ([ENTER]). A blinking question mark 
(?) appears.

Interface      

? Serial

Interface      

? Parallel

>Parallel I/F

? Nibble (high)