American Dynamics ad1646 Installation Instruction
Pan/Tilt and Lens Cable
The connection to a Pan/Tilt and a motorized Lens is with a
12-pin connector. This connector (J6) is located on the side of
the unit (see Figure 5, page 8).
12-pin connector. This connector (J6) is located on the side of
the unit (see Figure 5, page 8).
Table 8 above lists the pin designations from the Receiver to
the Pan/Tilt and the Lens units, and provides space for the
installer to record the pinouts for the specific installation.
Match the Pan/Tilt and Lens pinouts from the manufacturer’s
installation manuals to Table 8.
the Pan/Tilt and the Lens units, and provides space for the
installer to record the pinouts for the specific installation.
Match the Pan/Tilt and Lens pinouts from the manufacturer’s
installation manuals to Table 8.
In using the supplied connector plugs, insert each wire
carefully with approximately 1/4-inch of insulation removed.
Screw down the clamping screw on each pin of the connector.
carefully with approximately 1/4-inch of insulation removed.
Screw down the clamping screw on each pin of the connector.
Before Starting:
1. Check the power line to verify that the power is off.
2. Find the Pan/Tilt and Lens connector (J6) located on
the PCB (see Figure 5, page 8).
For steps 3 through 9, refer to Table 8 for the pinouts.
Pan/Tilt:
3. Insert the PAN wire of the Pan/Tilt unit into the pin
location for PAN, pin 6.
4. Insert the TILT wire of the Pan/Tilt unit into the pin
location for TILT, pin 7.
5. Insert the Pan/Tilt DC COMMON of the Pan/Tilt unit
into the pin location for GND, pin 9.
Lens:
6. Insert the IRIS wire of the Lens unit into the pin
location for IRIS, pin 3.
7. Insert the FOCUS wire of the Lens unit into the pin
location for FOCUS, pin 1.
8. Insert the ZOOM wire of the Lens unit into the pin
location for ZOOM, pin 2.
9. Insert the LENS DC COMMON wire of the Lens unit
into the pin location for GND, pin 4.
Cable Shield:
For outdoor installations, or where required by local
codes, insert the cable shield wire for each cable into
the pin location for SHIELD on the Preposition and
Auxiliary connector J7, page 13.
codes, insert the cable shield wire for each cable into
the pin location for SHIELD on the Preposition and
Auxiliary connector J7, page 13.
12
CONNECTIONS
Table 8 - Pan/Tilt and Lens 12-pin Connector Pinout (J6)
PIN NO.
FUNCTION
PAN/TILT PINOUT
LENS PINOUT
01
FOCUS
____________________
____________________
02
ZOOM
____________________
____________________
03
IRIS
____________________
____________________
04
GND
____________________
____________________
05
No Connection
____________________
____________________
06
PAN
____________________
____________________
07
TILT
____________________
____________________
08
No Connection
____________________
____________________
09
GND
____________________
____________________
10
ALARM 1
Not applicable for 1646M or S units
11
ALARM 2
Not applicable for 1646M or S units
12 GND
____________________
____________________