Plus bf-030 w Operating Guide

7

1. Avoid placing the machine in hot spots where it is exposed to direct sunlight or

where an air conditioning duct.

2. When using sticky tape on the surface of the board screen, do not leave it on for a

long time. Moreover, after removing it, wipe the screen clean. Do not hit or pierce
the board screen with any hard or sharp objects.

3. Do not leave writing or marks on the board screen for a long time since it sometimes

become difficult to erase.

4. Be careful not to stain the joints of the board screen as there have been very rare

cases where such stains have been copied.

5. As thinner, benzine, alcohol, etc., may discolor or mark the main unit and the

board screen, never use such chemicals when cleaning.

6. Use only the correct type of recording paper.

When storing thermal recording paper, avoid the following places. This is important
because storage in such places may cause color development or discoloration.
(1) Places where the paper is exposed to direct sunlight.
(2) Places where the paper is exposed to temperatures of more than 35˚C and

humidity of 85% or over.

(3) Places adjacent to alcohol, thinner, benzine, ammonia, etc.

Carry out the following maintenance procedures periodically to ensure high quality
copying performance at all times.
(1) Cleaning of the surface

When the surface gets stained, wipe it off with a slightly damp cloth. Also, if the stain
is particularly stubborn, use a solution of water-thinned neutral detergent to wipe it
off. Do not start using the machine until the sheet has completely dried.

(2) Cleaning of tray and decorative frame

Wipe away any dirt or residue left by the markers in the tray and the decorative
frame with a slightly damp cloth.