Plus bf-030spp User Manual

10

30mm

30mm

20mm

20mm

Conduct regular maintenance as described below to insure clear copies at all times.
(1) Cleaning the writing surface.

If the writing surface is dirty, use a damp cloth to clean it off.  In case of severe build-
up, use a neutral cleaner diluted in water.  Be sure the sheet is completely dry
before operating the equipment again.

(2) Cleaning the accessory tray and frame.

Use a damp cloth to clean off any residue from markers on the accessory tray and
frame.

1. Avoid placing the board in hot or cold areas where it is exposed to direct sunlight

or next to an air conditioning duct.

2. When using sticky tape on the surface of the writing surface to attach paper originals,

be sure to remove it at once when finished. Moreover, after removing it, wipe the
writing surface clean.
Do not hit or pierce the panel with any hard or sharp objects.

3. Do not leave writing or marks on pages 1-4 for a long time since it may become

difficult to erase.

4. As thinner, benzine, alcohol, etc., may discolor or mark the main unit and the

writing surface never use such chemicals when cleaning.

5. After use, be sure to turn OFF the power switch. In addition, when it is not to be

used for a long time, make certain that the plug is pulled form the outlet.

6. Always use the correct type of marker. Be careful not to use other markers as the

panel may be damaged or, in some cases, the ink may be difficult to remove.

7. To ensure all information will be printed, leave a slight margin around the edge of

the panel as indicated below.

8. When moving this machine, disengage the caster locks, hold both the right and

the left sides of the main unit firmly, and avoid any sudden jolts or shocks.