Blomberg taf 1230 User Manual

Operate the appliance only in well
ventilated, low dust rooms. Do not
block or cover the appliance's vent
slots.
The floor must have a sufficient load-
bearing capacity! If, for example, you
are stacking a washer and the dryer,
this combination can – when loaded –
reach a total weight of 160 kg.

Important:

• Place appliance on an even and level

floor only.

• Do not stand appliance on the power

cable.

• Keep at least 1 cm distance to walls or

other furniture.

The appliance has three exhaust outlets, at
the rear and the side panels; the side out-
lets are closed by removable covers.

The exhaust air should not be simply
led into the room, since the high hu-
midity may cause longterm damage
to walls and furniture.

• Connect the vent tube with the 90°

offset connector or the straight one
 to one of the exhaust air outlets.

• The two other outlets not used must

be closed by the covers.

The vent tube

– can be run through an open window

to the outside;

– can be connected to a wall-mount

vent.

The exhaust air must not be led into
flues or chimneys of fireplaces. Check
with your chimney sweeper or heating
engineer.

• Instead of the vent tube vent pipes

can be used. The diameter should be
at least 10 cm.

• Tube or pipe, respectively, should be

routed in the straightest and most di-
rect pathoutdoors, i.e. with the fewest
number of elbows and turns, as these
hamper airflow.

• The maximum length of a straight

routed tube/pipe is given in the chart
below.

• For each elbow and other obstructions

the respective value shown is to be de-
ducted from the maximum length.

This appliance can be installed under a
worktop.

• For this a special top cover is required

(stock no. AP 2000), available at the
customer service or specialised trade.

8.0 m

10.0 m

1 elbow 45°

– 1.0 m

– 0.3 m

1 elbow 90°

– 1.8 m

– 0.6 m

1 elbow 90° short turn

– 2.7 m

1 wall-mount vent* 

–  2.0 m

– 2.0 m

* with automatic louvers

4