Panasonic AG-HVX200 User Guide

Press the ZEBRA button in the camera mode to 
show the zebra pattern or marker on the screen so 
you can check the brightness of the subject.
Parts that may be whited out through over 
exposure are shown as a zebra pattern.
• Very bright
• Reflecting parts
You can remove most overexposed parts by 
adjusting the iris and shutter speed in the manual 
mode to remove the areas with zebra patterns.
The display changes as follows each time you 
press the ZEBRA button.

In the setup menus, DISPLAY SETUP screen, 
ZEBRA DETECT 1 and ZEBRA DETECT 2, set the 
brightness for the zebra patterns. (Page 112)
The zebra pattern you have set appears as a 
percentage on the display for about 2 seconds.

If you press the ZEBRA button again while the 
zebra pattern is being displayed, a marker appears 
in the center of the display (if you have set the 
setup menu, DISPLAY SETUP, MARKER to ON).
The brightness of the areas near the screen center 
can be checked as a percentage (0% to 99%).
“99%↑” appears if the percentage is over 99.

The normal display reappears if you press the 
ZEBRA button again.

CH 1 SELECT CH 2 SELECT

INPUT 1

INPUT 2

INT(L)

INPUT 1
INPUT 2

INT(R)

INPUT 2

ON

OFF

MIC POWER +48V

BARS

AUDIO

SHUTTER

SPEED SEL

COUNTER RESET/TC SET

ZEBRA

OIS

RESET

ON

OFF

ZEBRA 1 → ZEBRA 2

 

 

↑   

↓

           OFF ← MARKER