Panasonic dmc-ls1 User Manual

Connecting to a PC or Printer

86

VQT0Q58

By connecting the camera directly to a 
printer supporting PictBridge via the USB 
connection cable (supplied), you can select 
the pictures to be printed or start printing 
on the LCD monitor.
Set the print settings such as print quality 
on the printer beforehand. (Read the printer 
operating instructions.)

A: USB connection cable (supplied)
B: AC adaptor (DMW-AC1; optional)

A 

• Connect the USB connection cable with 

the [

] mark facing the [

1] mark on 

the [DIGITAL] socket.

• Hold the plug 

C to push into or pull out.

• It may take time to print some pictures. 

Therefore, use batteries with sufficient 
battery power (P14) or the AC adaptor 
(DMW-AC1; optional) when you connect 
to a printer.

• If the remaining battery power becomes 

low during communication, the status 
indicator blinks and the alarm beeps. In 
this case, stop the communication at 
once.

• Disconnect the USB connection cable 

after printing.

• Do not use any other USB connection 

cables except the supplied one.

• If the card is not inserted when the 

camera is connected to a printer, you can 
edit or access the picture data in the 
built-in memory. If the card is inserted, you 
can edit or access the picture data in it.

• You cannot switch the recording medium 

between the built-in memory and the card 
while the camera is connected to the 
printer. When you want to switch the 
recording medium, disconnect the USB 
connection cable, insert (or remove) the 
card and then connect the USB 
connection cable to the printer again.

When the DPOF 
Print is not set.

Select [SINGLE 
PICTURE]. (P87)

When the DPOF 
Print is set. (P72)

Select [DPOF 
PICTURE]. (P88)

VQT0Q58ENG.book  86 ページ  ２００５年２月３日　木曜日　午後７時０分