Panasonic AG-HPX370 User Manual

5

Chapter

Recording

and
Pla
ybac

k

This section describes the basic procedure for shooting 
and recording.
Before you embark on a shoot, pre-inspect your system to 
ensure that it works properly.
For directions on inspecting your memory card camera-
recorder, see [Inspections Before Shooting] (page 157).

Insertachargedbattery.

TurnthePOWERswitchtoONtocheckthe
batteryremaininglevelintheviewfinder.

•  When battery capacity is low, replace it with a fully 

charged battery.



When low battery capacity is indicated after replacing 
a battery with a fully charged battery, check battery 
installation.
For details, refer to [BATTERY SETUP screen] (page 144).

InsertaPcard,checkthatthePCARD
ACCESSLEDlightsorangeorgreenbefore
closingtheslotcover.

•  When more than one P2 card slot contains a P2 

card, the card in the slot with the lowest number 
is used first. However, regardless of slot number, 
a P2 card inserted later will not be accessed until 
the other cards have been used.

Example: 

If the two slots contain P2 cards, the cards are 
used in order of slot numbers 12. However, if 
the P2 card in Slot 1 is removed and then re-
inserted, the cards will be used in the following 
order: 21.

1

2

Note that the recording order is retained even if the power 
is turned off. When the power is next turned on, the last 
card written before powering-down will be the target card.