Panasonic vdr-m30 User Guide

Page of 176
157
QR34662
Troubleshooting
Check to see the following before asking for a repair. If the suggested solution still cannot restore the DVD 
Palmcorder to normal, do not attempt to repair it yourself, but call 1-800-211-PANA for support.
Power supplies
Symptom
Cause and Correction
Reference 
page
Battery pack cannot be 
charged.
*
If the battery pack does 
not charge after you try 
the four procedures 
shown on the right, it 
may be dead: 
Purchase a new 
battery pack.
Is the ambient temperature too low or too high?
Charge the battery pack at 50-86ºF (10-30ºC).
38
Is the battery pack abnormally hot?
Remove the battery pack, leave it for a while to cool down, then 
charge it.
Is the DC cord connected to AC adapter/charger? Unplug it.
Has the battery pack been unused for a long time?
Remove the battery pack, and then reattach it.
Battery pack weakens 
fast.
Are you using the DVD Palmcorder where the temperature is very 
low?
The DVD Palmcorder can normally be used for 40-60 minutes with 
a fully charged CGA-DU14A battery pack, but this time will be 
shorter at low temperatures. Keep extra batteries on hand.
40
Battery pack may be dead.
The performance of battery pack will deteriorate if it is used for an 
extended period of time or frequently: Purchase a new battery.
41
The CHARGE indicator 
on AC adapter/charger is 
blinking.
Is the ambient temperature too low or too high?
Charge the battery pack in environment where the temperature is 
50-86°F (10-30°). 
The battery pack has possibly discharged excessively. Continue 
charging: After a while, the battery pack will be charged to the 
specified voltage, and the CHARGE indicator will light. Then the 
battery charge will be completed normally.
38
Power turns off 
immediately after being 
turned on.
Is battery pack charged?
Charge it.
38
When power is turned 
on, the LCD screen will 
turn on and off.
Power goes off  
unexpectedly.
Is Power Save set to “On”? 
If the powered DVD Palmcorder is left for as long as 5 minutes 
without recording or playback with “Power Save: On” specified, it will 
automatically turn off to save battery power. To restart recording in 
this case, set the power switch to “POWER OFF” and then set it to 
 VIDEO”. You can also specify “Power Save: Off” to stop 
automatic power off.
94
Power cannot be turned 
off.
Detach the battery pack or AC adapter/charger once, and then press 
the RESET button of DVD Palmcorder: Reattach a power supply to 
DVD Palmcorder before turning it on again.
VDR-M30PP_GB.book Page 157 Friday, March 14, 2003 8:53 PM