Panasonic pt-43lcx64 Supplementary Manual

Lamp replacement procedure

Turn power off, wait until power

indicator stops blinking red, then

unplug the power cord from the

wall outlet and confirm that the area

around the lamp unit has cooled

down.

POWER

button /

POWER

indicator

Lamp Re placement

Loosen the Lamp cover screw.

First read caution and warn ing

labels on lamp cover. Then, loosen

the lamp cover screw by using a

screwdriver.

Lamp unit screw

Screwdriver

Loosen the lamp unit screw with a

screwdriver. Then, grasp the lamp

unit as shown in the diagram, and

slowly remove from the projection

display.

Remove the Front cover. Place your

fingertips under the Front cover and

pull it from the projection display.

Lamp unit handle

Lamp cover handle

Replace the Lamp unit and cover

screws. Tighten the lamp unit/cover

screw with a screwdriver.

• Properly dispose of old lamp. Please see the

operating instructions for the projection display.

Note

Replace the Front cover.

Insert the new lamp unit being careful

of the insertion direction.

• Press on the arrow mark making sure

insertion is done correctly.

Lamp time reset procedure

Be sure the power cord is plugged

into a properly grounded wall outlet.

Then, press the POWER button on the

projection display or the remote control

to turn the unit on.

Warning:

Perform lamp time reset only when the lamp has

been replaced.

When lamp time reset is finished, the LAMP

indicator goes out.

Note

After lamp re placement,

follow the pro cedure below

When reset

procedure

is complete,

the screen on

the right will

appear.

and

Lamp cover screw

LAMP indicator

While pressing the VOL- button on

the projection display, hold down the

PIP or SPLIT button on the remote

control at same time for more than

5 seconds.

LSQC0334 C

LAMP TIME WAS
RESET TO 0.

END

Front cover

This product has a High Intensity Discharge (HID)

lamp that contains a small amount of mercury.

Disposal of these materials may be regulated

in your community due to environmental

considerations.

For disposal or recycling information please contact

your local authorities, or the Electronics Industries

Alliance: <http://www.eiae.org.>

CAUTION:

Because of the possibility of injury, strictly follow

the replacement procedure below.

• Please wait more than one hour for lamp

replacement.

[If you need to replace the lamp more urgently]

• The Projection display has a forced cooling

feature. After the POWER button is turned OFF,

and during the first minute of the normal cooling

fan operation, press the VOL+ button on the

projection display and button on the remote

control at same time for more than 5 seconds. The

cooling fan operates for about 10 minutes. The

LAMP indicator flashes red 5 times every 5

seconds.

Attach the lamp unit and lamp unit housing door

securely. If the lamp unit and lamp unit housing

door are not attached securely, the protective

circuit will be activated and the lamp will not turn

on.

* This screen may be

different from the actual

screen.

For models PT-50LC13/

PT-60LC13/PT-50LCX63/

PT-60LCX63/PT-43LCX64/

PT-50LCX64/PT-60LCX64

For models PT-43LC14/

PT-50LC14/PT-60LC14

CAUTION

• Because the lamp unit is hot immediately after

its use, touching it may cause burns.

Please allow the lamp to cool before handling or

replacing the lamp unit.

•