Panasonic th-42pf30 User Guide

Cannot see 3D images

•  Has the 3D Eyewear been switched On?
•  Ensure that “3D EYEWEAR” in “3D SETTINGS” is set to “ON”. (see 

page 36)

•  Some 3D image signals may not be automatically recognized as 3D 

images. Set “3D INPUT FORMAT” in “3D SETTINGS” to match the 
picture format. (see page 36)

•  Check that there are no obstacles between the infrared sensors on 

the display and the 3D Eyewear. If the 3D Eyewear stops receiving the 
infrared signal for about 5 minutes, the 3D Eyewear will be turned off 
automatically.

•  Check the available area to use the 3D Eyewear.
•  Depending on the person, the 3D images may be dif cult to see, or 

cannot be seen, especially in users that have a different level of eyesight 
between the left and right eyes. 
Take the necessary steps (wearing glasses etc.) to correct your eyesight 
before use.

3D Eyewear is turned off automatically

•  Check that there are no obstacles between the infrared sensors on the 

display and the 3D Eyewear or that the 3D Eyewear is placed inside the 
coverage area. If the 3D Eyewear stops receiving the infrared signal for 
about 5 minutes, the 3D Eyewear will be turned off automatically.

There is something wrong with the 3D 
images

•  Switch “SWAPPED” and “NORMAL” under “LEFT/RIGHT SWAP” in “3D 

SETTINGS” (see page 36).

Indicator lamp will not light when the 3D 
glasses are turned ON.

•  The battery may be running low or  at. Change the battery or charge the 

3D glasses.

If the picture appears to be abnormal, refer to the table below to choose the correct 3D picture format setting.

*

1

Normal*

2

*

1

Normal*

2

Normal

Normal

*1

 When the source image is not recognized correctly

*2

  When “3D EYEWEAR” is set to “ON”, the images will be displayed with 3D effect. When set to “OFF”, displayed 

without 3D effect.

•  Depending on the player or contents, the image may be different from the above illustrations.