Panasonic th-47lf30 User Guide

OFF

0

NORMAL

NORMALIZE

AUTO SETUP

POS. /SIZE

V-POS

0

H-POS

V-SIZE
CLOCK PHASE

H-SIZE

1:1 PIXEL MODE

DOT CLOCK

0
0
0

0

Note:
Unadjustable items are grayed out.
Adjustable items differ 
depending on the input signal 
and the display mode.

Press to display the POS. /SIZE menu.

Press to select the menu to adjust.

Press to adjust the menu.

Press to exit from adjust mode.

Note:
If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This picture 
position movement cannot be controlled by the POS. /SIZE function.

H-POS/V-POS, H-SIZE/V-SIZE, DOT CLOCK and CLOCK PHASE are automatically adjusted when the 
RGB or PC signal is received.
This setting only operates when a PC signal or RGB signal is input, and the aspect is “FULL”.

When 

 on the remote control is pressed, “AUTO SETUP” will be executed.

When AUTO SETUP does not work, “INVALID” is displayed.

Notes:
•  AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright image 

with borders and other objects are clearly shown, and then try auto setup again.

• Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out fi ne tuning for the 

position/size as required.

• If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz and 

1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page 40) may results in correct 
AUTO SETUP.

• AUTO SETUP does not work well when a signal such as additional information is superimposed out of 

valid image period or intervals between synchronizing and image signals are short.

• If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press ACTION ( ) then adjust 

POS. /SIZE manually.

•  If the picture goes off screen in the horizontal direction as a result of performing AUTO SETUP, perform 

DOT CLOCK adjustment.