Panasonic tx-26lx70 User Guide

•

Licence 

•

Speci

fi cations

•

Frequently Asked 

Questions

AC 220-240 V, 50 / 60 Hz

100 W

134 W

0.4 W

16:9

66 cm (diagonal)

80 cm (diagonal)

575 mm (W) × 323 mm (H)

697 mm (W) × 392 mm (H)

1,049,088 (1,366 (W) × 768 (H))

120 mm × 60 mm × 2 pcs

20 W (10 W + 10 W)

M3 (3.5 mm) stereo mini Jack × 1

VGA, SVGA, XGA

SXGA ······ (compressed)

Horizontal scanning frequency 31 - 69 kHz

Vertical scanning frequency 59 - 86 Hz

PAL I 

UHF E21-68 / VHF Ireland channel

PAL 525/60 

Playback of NTSC tape from some PAL Video recorders (VCR) or 

NTSC disc playback from DVD player and recorder.

M.NTSC 

Playback from M. NTSC Video recorders (VCR).

NTSC (AV input only) Playback from NTSC Video recorders (VCR).

VHF / UHF

Temperature  : 0 °C - 35 °C

Humidity 

: 20 % - 80 % RH (non-condensing)

21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, Q-Link)

21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, S-Video in, Q-Link)

RCA PIN Type × 1 

1.0 V[p-p] (75 Ω)

Mini DIN 4-pin 

Y:1.0 V[p-p] (75 Ω) C:0.286 V[p-p] (75 Ω)

RCA PIN Type × 2 

0.5 V[rms]

Y 

1.0 V[p-p] (including synchronization)

 ±0.35 

V[p-p]

RCA PIN Type × 2 

0.5 V[rms]

TYPE A Connectors

HIGH-DENSITY D-SUB 15PIN 

R,G,B/0.7 V[p-p] (75 Ω)

 

HD, VD/TTL Level 2.0 - 5.0 V[p-p] (high impedance)

RCA PIN Type × 2 

0.5 V[rms] (high impedance)

657 mm × 525 mm × 216 mm (With TV Stand)

657 mm × 473 mm × 117 mm (TV only)

791 mm × 615 mm × 248 mm (With TV Stand)

791 mm × 563 mm × 117 mm (TV only)

14.0 k  Net

17.5 k  Net

38

39

• 

Set “P-NR” in the Picture Menu (to remove noise). (p. 20)

• 

Check nearby electrical products

(car, motorcycle, fl uorescent lamp).

• 

Is “Colour” or “Contrast” in the Picture Menu set to the minimum? 

(p. 20)

• 

Check Colour system. (p. 23)

(no sound or low volume)

• 

Reset channels. (p. 22)

• 

Is “Sound mute” active? (p. 7)

• 

Is the volume set to the minimum?

• 

Sound signal reception may be deteriorated.

• 

Set “MPX” (p. 20) in the Sound Menu to “Mono”.

• 

Check Sound system. (p. 23)

• 

Set the sound setting of the connected equipment to 

“2ch L.PCM”.

• 

Check the “HDMI1 Input” setting in the Sound Menu. (p. 20)

• 

If digital sound connection has a problem, select analogue sound 

connection. (p. 29)

• 

Is the HDMI cable connected properly? (p. 32)

• 

Turn Off the TV and equipment, then turn them On again.

• 

Check an input signal from the equipment. (p. 36)

• 

Use an equipment compliant with EIA/CEA-861/861B.

• 

Turn off the TV with Mains power On / Off switch, then turn it on 

again.

• 

Off Timer function is activated.

• 

The TV enters “Standby mode” about 30 min. after broadcasting 

ends.

• 

Are the batteries installed correctly? (p. 6)

• 

Has the TV been switched On?

• 

Follow the message’s instructions.

• 

If the problem persists, contact the authorized Service Centre.

• 

VGA is a trademark of International Business Machines Corporation.

• 

Macintosh is a registered trademark of Apple Computer, USA.

• 

S-VGA is a registered trademark of the Video Electronics Standard Association.

Even if no special notation has been made of company or product trademarks, these trademarks have been fully 

respected.

• 

HDMI, the HDMI Logo and High-Defi nition Multimedia Interface are trademarks or registered trademarks of HDMI 

Licensing LLC.

• 

HDAVI Control

TM

 is a trademark of Matsushita Electric Industrial Co., Ltd.

• 

Design and Specifi cations are subject to change without notice. Weight and Dimensions shown are approximate.

• 

This equipment complies with the EMC standards listed below. 

EN55013, EN61000-3-2, EN61000-3-3, EN55020, EN55022, EN55024.

• 

This TV supports “HDAVI Control 2” function.