Panasonic tc-l24x5 User Guide

RISK OF ELECTRIC SHOCK 

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

The lightning flash with arrowhead within a 

triangle is intended to tell the user that parts 

inside the product are a risk of electric shock 

to persons.

The exclamation point within a triangle is 

intended to tell the user that important 

operating and servicing instructions are in 

the papers with the appliance.

This reminder is provided to direct the CATV system 

installer’s attention to Article 820-40 of the NEC that provides 

guidelines for proper grounding and, in particular, specifies 

that the cable ground shall be connected to the grounding 

system of the building, as close to the point of cable entry as 

practical.

Slots and openings in the cabinet and the back or bottom 

are provided for ventilation, and to ensure reliable operation 

of the LCD TV and to protect it from overheating. These 

openings must not be blocked or covered. There should be 

at least 10 cm of space around the TV. The openings should 

never be blocked by placing the LCD TV on a bed, sofa, rug or 

other similar surface. This

LCD TV should not be placed in a built-in installation such as a 

bookcase unless proper ventilation is provided.

1.  Read these instructions.

2.  Keep these instructions.

3.  Heed all warnings.

4.  Follow all instructions.

5.  Do not use this apparatus near water.

6.  Clean only with dry cloth.

7.  Do not block any ventilation openings. Install in 

accordance with the manufacturer’s instructions.

8.  Do not install near any heat sources such as radiators, 

heat registers, stoves, or other apparatus (including 
amplifiers) that produce heat.

9.  Do not defeat the safety purpose of the polarized or 

grounding-type plug. A polarized plug has two blades 

with one wider than the other. A grounding type plug 

has two blades and a third grounding prong. The wide 

blade or the third prong are provided for your safety. If 

the provided plug does not fit into your outlet, consult an 

electrician for replacement of the obsolete outlet.

10.  Protect the power cord from being walked on or pinched 

particularly at plugs, convenience receptacles, and the 

point where they exit from the apparatus.

11.  Only use attachments/accessories specified by the 

manufacturer.

12.  Use only with the cart, stand, tripod, bracket, or 

table specified by the manufacturer, or sold with the 

apparatus. When a cart is used, use caution when moving 

the cart/apparatus combination to avoid injury from 

tip-over.

13.  Unplug this apparatus during lightning storms or when 

unused for long periods of time.

14.  Refer all servicing to qualified service personnel. 

Servicing is required when the apparatus has been 

damaged in any way, such as power-supply cord or plug 

is damaged, liquid has been spilled or objects have fallen 

into the apparatus, the apparatus has been exposed to 

rain or moisture, does not operate normally, or has been 

dropped.

15.  Operate only from the type of power source indicated on 

the marking label. If you are not sure of the type of power 

supplied to your home consult your television dealer or 

local power company.

16.  Follow all warnings and instructions marked on the LCD 

TV.

17.  Never push objects of any kind into this LCD TV through 

cabinet slots as they may touch dangerous voltage points 

or short out parts that could result in a fire or electric 

shock. Never spill liquid of any kind on the LCD TV.

18.  If an outside antenna is connected to the television 

equipment, be sure the antenna system is grounded so 

as to provide some protection against voltage surges 

and built up static charges. In the U.S. Section 810-21 of 

the National Electrical Code provides information with 

respect to proper grounding of the mast and supporting 

structure, grounding of the lead-in wire to an antenna 

discharge unit, size of grounding conductors, location 

of antenna discharge unit, connection to grounding 

electrodes, and requirements for the grounding 

electrode.