Billion 5100 User Guide

 

14

Step 1. Make sure the SYS LED is on (not blinking). 

Step 2. Press the RESET button for five seconds, and then release it. When the SYS LED 

begins to blink, the defaults have been restored and the BIPAC-5100/5100W restarts. 

Download the default configuration file from the Billion FTP site, unzip it and save it in a folder. 

Step 1. Turn off the BIPAC-5100/5100W, begin a terminal emulation software session and 

turn on the BIPAC-5100/5100W again. When you see the message "Press Any key to 

enter Debug Mode within 3 seconds", press any key to enter debug mode. 

Step 2. Enter "atlc" after "Enter Debug Mode" message. 

Step 3. Wait for "Starting XMODEM upload" message before activating Xmodem upload on 

your terminal. This is an example Xmodem configuration upload using HyperTerminal. 

Step 4. Click Transfer, then Send File to display the following screen. 

 

Step 5. After successful firmware upload, enter "atgo" to restart the router.