Panasonic kx-tg2352 User Guide

The unit does not work.

“No link to base
Move closer to base,

try again

” is displayed

and an alarm tone sounds.

Static, sound cuts in/out,
fades. Interference from
other electrical units.

The handset does not ring.

The handset display is
blank.

•Check the settings (p. 8–10).

•Check whether the dialing mode setting is

correct (p. 14).

•Charge the battery fully (p. 9, 10).

•Clean the charge contacts and charge again

(p. 10).

•Install the battery properly (p. 9).

•Unplug the AC adaptor of the base unit to

reset. Plug in, and try again.

•The handset has not been registered to the

base unit. Register the handset (p. 19, 55).

•Re-install the battery (p. 53) and charge it

fully.

•You are too far from the base unit. 

Move closer to the base unit and try again.

•Plug in the AC adaptor of the base unit.

•Raise the base unit antenna.

•Locate the handset and the base unit away

from other electrical appliances (p. 3).

•Move closer to the base unit.

•Raise the base unit antenna.

•The ringer volume is OFF. Set to HIGH or

MEDIUM or LOW (p. 17).

•While you are making an intercom call, these

handsets do not ring. Instead users will hear
incoming call tones (p. 49).

•Charge the battery fully (p. 9, 10).