Panasonic vb-44210 User Guide

Section 700 - Operation

Chapter 3. System Features

DBS-2.3/9.2-700

DBS Manual - Revised April 2000

  Page 3-43

4.  From your terminal communications program, type the following 

command:

#99xxxx (where xxxx = the site’s password)

5.  After the DBS responds, type P and then press Enter.

Follow the directions on the screen to access the desired program. (See 
“Terminal Programming Commands.”)

Note: The DBS must be equipped with an MFR card and a RAI card to allow 
terminal programming using this method.

When programming through a DISA trunk, perform the following steps:

1.  Dial into the DBS through a DISA trunk.

2.  Once you are connected, type #69999 from your terminal communications 

program. 

3.  After the DBS responds with REMT>, type P and then press Enter.

Follow the directions on the screen to access the desired program. (See 
“Terminal Programming Commands.”)

Note: The DBS must be equipped with an MFR card and a RAI card to allow 
terminal programming using this method.

When programming through a normal trunk, perform the following steps:

1.  Dial into the DBS through a normal trunk.

2.  Ask the operator to place you on hold and dial #69999 to transfer you into 

remote programming. 

3.  After the DBS responds with REMT>, type P and then press Enter.

Follow the directions on the screen to access the desired program. (See 
“Terminal Programming Commands.”)