Panasonic vb-44210 User Guide
Section 700 - Operation
Chapter 3. System Features
DBS-2.3/9.2-700
DBS Manual - Revised April 2000
Page 3-43
4. From your terminal communications program, type the following
command:
#99xxxx (where xxxx = the site’s password)
5. After the DBS responds, type P and then press Enter.
Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
“Terminal Programming Commands.”)
Terminal Programming Through DISA
Note: The DBS must be equipped with an MFR card and a RAI card to allow
terminal programming using this method.
terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
1. Dial into the DBS through a DISA trunk.
2. Once you are connected, type #69999 from your terminal communications
program.
3. After the DBS responds with REMT>, type P and then press Enter.
Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
“Terminal Programming Commands.”)
Terminal Programming Through a CO Trunk and Operator Transfer
Note: The DBS must be equipped with an MFR card and a RAI card to allow
terminal programming using this method.
terminal programming using this method.
When programming through a normal trunk, perform the following steps:
1. Dial into the DBS through a normal trunk.
2. Ask the operator to place you on hold and dial #69999 to transfer you into
remote programming.
3. After the DBS responds with REMT>, type P and then press Enter.
Follow the directions on the screen to access the desired program. (See
“Terminal Programming Commands.”)
“Terminal Programming Commands.”)