Sony CDX-SW200 Installation Instruction

© 2004 Sony Corporation   

Printed in Korea

  

3-261-841-61

 

(1)

• This unit is designed for negative ground 12 V DC

operation only.

• Do not get the leads under a screw, or caught in

moving parts (e.g. seat railing).

• Before making connections, turn the car ignition

off to avoid short circuits.

• Connect the yellow and red power input leads

only after all other leads have been connected.

• Run all ground leads to a common ground

• Be sure to insulate any loose unconnected leads

with electrical tape for safety.

• The use of optical instruments with this product

will increase eye hazard.

Notes on the power supply lead (yellow)
• When connecting this unit in combination with

other stereo components, the connected car
circuit’s rating must be higher than the sum of
each component’s fuse.

• When no car circuits are rated high enough,

connect the unit directly to the battery.

Parts Iist (1)

• The numbers in the list are keyed to those in the

instructions.

• The bracket 1 and the protection collar 3 are

attached to the unit before shipping. Before
mounting the unit, use the release keys 5 to
remove the bracket 1 and the protection collar 3
from the unit. For details, see “Removing the
protection collar and the bracket (4)” on the
reverse side of the sheet.

• Keep the release keys 5 for future use as they

Handle the bracket 1 carefully to avoid injuring
your fingers.

Note
Before installing, make sure that the catches on
both sides of the bracket 1 are bent inwards 2 mm
(

Installation/Connections

Instalación/Conexiones

Connection example (2)

Notes (2-B)
• Be sure to connect the ground lead before

Connection diagram (3)

1

To a metal surface of the car
First connect the black ground lead, then
connect the yellow and red power input leads.

2

To the power antenna control lead or power
supply lead of antenna booster amplifier
Notes
• It is not necessary to connect this lead if

3

To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers.
Connecting any other system may damage the
unit.

4

To the +12 V power terminal which is
energized in the accessory position of the
ignition key switch
Notes
• If there is no accessory position, connect to

5

To the +12 V power terminal which is
energized at all times
Be sure to connect the black ground lead to a
metal surface of the car first.

1

4

5

×

 4

2

×

 2

3

1