Sony MEX-BT2500 User Guide

Be sure to install this unit in the dashboard of 
the car for safety. For installation and 
connections, see the supplied installation/
connections manual.

This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules 
and RSS-Gen of IC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment

  and receiver.

– Connect the equipment into an outlet on a

  circuit different from that to which the receiver
  is connected.

– Consult the dealer or an experienced radio/TV

  technician for help.

This transmitter must not be co-located or 
operated in conjunction with any other antenna 
or transmitter.

This equipment complies with FCC and IC 
radiation exposure limits set forth for 
uncontrolled equipment and meets the FCC 
radio frequency (RF) Exposure Guidelines in 
Supplement C to OET65 and RSS-102 of the 
IC radio frequency (RF) Exposure rules. This 
equipment has very low levels of RF energy 
that it deemed to comply without maximum 
permissive exposure evaluation (MPE). But it 
is desirable that it should be installed and 
operated with at least 20 cm and more between 
the radiator and person's body (excluding 
extremities: hands, wrists, feet and legs).

You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.

Warning if your car’s ignition has no 
ACC position
Be sure to set the Auto Off function (page 15).
The unit will shut off completely and 
automatically in the set time after the unit is 
turned off, which prevents battery drain.
If you do not set the Auto Off function, press 
and hold (OFF) until the display disappears 
each time you turn the ignition off.

The use of optical instruments with this product
will increase eye hazard.

Perchlorate Material – special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material: Lithium battery contains 
perchlorate