3com 5500-ei pwr Installation Instruction

 

1-32 

Figure 1-7 Network diagram for the SNMP test 

 

 

 

z 

Configure SNMP Agent (Switch B): 

# Start SNMP agent and set SNMP version to V2C, read-only community name to public, and 

read-write community name to private. 

<Sysname> system-view 

[Sysname] snmp-agent 

[Sysname] snmp-agent sys-info version v2c 

[Sysname] snmp-agent community read public 

[Sysname] snmp-agent community write private    

 

z 

The SNMP network management function must be enabled on SNMP agent before it can receive 

response packets. 

z 

The SNMPv2c version is used as reference in this example. This configuration may differ if the 

system uses any other version of SNMP. For details, see SNMP – RMON  Operation Manual. 

 

z 

Configure remote-ping Client (Switch A): 

# Enable the remote-ping client. 

<Sysname> system-view 

[Sysname] remote-ping-agent enable 

# Create a remote-ping test group, setting the administrator name to administrator and test tag to 

snmp.  

[Sysname] remote-ping administrator snmp 

# Configure the test type as snmp.  

[Sysname-remote-ping-administrator-snmp] test-type snmpquery 

# Configure the destination IP address as 10.2.2.2.  

[Sysname-remote-ping-administrator-snmp] destination-ip 10.2.2.2 

# Configure to make 10 probes per test.  

[Sysname-remote-ping-administrator-snmp] count 10 

# Set the probe timeout time to 30 seconds. 

[Sysname-remote-ping-administrator-snmp] timeout 30