3com 5500-ei pwr Installation Instruction

 

1-16 

Set 802.1x timers 

dot1x timer 
{ handshake-period 
handshake-period-value | 
quiet-period quiet-period-value | 
server-timeout 
server-timeout-value | 
supp-timeout 
supp-timeout-value | tx-period 
tx-period-value | ver-period 
ver-period-value } 

Optional 

The settings of 802.1x timers are 
as follows. 

1) handshake-period-value: 

15 seconds 

2) quiet-period-value: 

60 

seconds 

3) server-timeout-value:  100 

seconds  

4) supp-timeout-value: 

30 

seconds 

5)  tx-period-value: 30 seconds
6) ver-period-value: 

30 

seconds 

Enable the quiet-period 
timer 

Optional 

By default, the quiet-period timer 
is disabled. 

 

  Note: 

z 

As for the dot1x max-user command, if you execute it in system view without specifying the 

interface-list argument, the command applies to all ports. You can also use this command in port 

view. In this case, this command applies to the current port only and the interface-list argument is 

not needed. 

z 

As for the configuration of 802.1x timers, the default values are recommended. 

 

Advanced 802.1x configurations, as listed below, are all optional. 

z 

Configuration concerning CAMS, including multiple network adapters detecting, proxy detecting, 

and so on. 

z 

Client version checking configuration 

z 

DHCP–triggered authentication 

z 

Guest VLAN configuration 

z 

802.1x re-authentication configuration 

z 

Configuration of the 802.1x re-authentication timer 

You need to configure basic 802.1x functions before configuring the above 802.1x features. 

Follow these steps to configure proxy checking: 

Enter system view 

— 

Enable proxy checking function 
globally 

dot1x supp-proxy-check 
{ logoff | trap } 

Required 

By default, the 802.1x proxy 
checking function is globally 
disabled.