3com 5500-ei pwr Installation Instruction
1-31
z
Set the maximum rate of outbound packets sourced from the marketing department to
64 kbps. Drop the packets exceeding the rate limit.
z
Set the maximum rate of outbound IP packets sent by PC 1 in the R&D department to
640 kbps. Drop the packets exceeding the rate limit.
Network diagram
Figure 1-9 Network diagram for traffic policing and rate limiting configuration
Configuration procedure
1) Define an ACL for traffic classification.
# Create ACL 2000 and enter basic ACL view.
<Sysname> system-view
[Sysname] acl number 2000
# Define a rule for the packets with 192.168.0.1 as the source IP address.
[Sysname-acl-basic-2000] rule permit source 192.168.0.1 0
[Sysname-acl-basic-2000] quit
2) Configure traffic policing and rate limiting
# Set the maximum rate of outbound packets sourced from the marketing department to 64
kbps.
[Sysname] interface Ethernet1/0/2
[Sysname-Ethernet1/0/2] line-rate inbound 64
[Sysname-Ethernet1/0/2] quit
# Set the maximum rate of outbound IP packets sent by PC 1 in the R&D department to 640
kbps.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-limit inbound ip-group 2000 640 exceed drop
Configuration Example of Priority Marking and Queue Scheduling
Network requirements
As shown in
, an enterprise network connects all the departments through an
Ethernet switch. Clients PC 1 through PC 3 are connected to Ethernet 1/0/1 of the switch;