3com 5500-ei pwr Installation Instruction

 

1-8 

z 

If the system information is output before you input any information following the current command 

line prompt, the system does not echo any command line prompt after the system information 

output. 

z 

In the interaction mode, you are prompted for some information input. If the input is interrupted by 

system output, no system prompt (except the Y/N string) will be echoed after the output, but your 

input will be displayed in a new line. 

 

To add UTC time zone to the time stamp in the information center output information, you must: 

z 

Set the local time zone 

z 

Set the time stamp format in the output destination of the information center to date 

z 

Configure to add the UTC time zone to the output information 

Follow these steps to configure to display time stamp with the UTC time zone: 

Set the time zone for the system 

clock timezone zone-name 
{ add | minus } time 

Required 

By default, UTC time zone is set 
for the system. 

Enter system view 

system-view 

— 

Log host 
direction 

info-center timestamp 
loghost date 

Set the time stamp 
format in the output 
destination of the 
information center 
to date 

Non log 
host 
direction 

info-center timestamp { log 
| trap | debugging } date 

Required 

Use either command 

Set to display the UTC time zone 
in the output information of the 
information center 

info-center timestamp utc 

Required 

By default, no UTC time zone is 
displayed in the output 
information 

 

Follow these steps to set to output system information to the console: 

Enter system view 

— 

Enable the 
information center 

info-center enable 

Optional 

Enabled by default.