3com 5500-ei pwr Installation Instruction
1-7
Figure 1-5 Sending file page
Step 9: After the sending process completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Step 10: Reset HyperTerminal’s baudrate to 9600 bps (refer to Step 4 and 5). Then, press any key as
prompted. The system will display the following information when it completes the loading.
Bootrom updating.....................................done!
z
If the HyperTerminal’s baudrate is not reset to 9600 bps, the system prompts "Your baudrate
should be set to 9600 bps again! Press enter key when ready".
z
You need not reset the HyperTerminal’s baudrate and can skip the last step if you have chosen
9600 bps. In this case, the system upgrades the Boot ROM automatically and prompts “Bootrom
updating now.....................................done!”.
Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in BOOT Menu and press <Enter>. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 2: Enter 3 in the above menu to load the host software by using XModem.