3com 5500-ei pwr Reference Guide

 

3-9 

Transceiver info I/O error 

Transceiver information read and write error 

Transceiver info checksum error 

Transceiver information checksum error 

Transceiver type and port configuration 
mismatch

 

Transceiver type does not match port configuration. 

Transceiver type not supported by port 
hardware

 

Transceiver type is not supported on the port. 

 

# Display the alarm information of the transceiver on interface GigabitEthernet 1/0/25. 

<Sysname> display transceiver alarm interface gigabitethernet 1/0/25 

GigabitEthernet1/0/25 transceiver current alarm information: 

  TX fault 

Table 3-6 Description on the fields of display transceiver alarm interface 

transceiver current alarm information 

Current alarm information of the transceiver 

TX fault 

TX fault 

 

display transceiver diagnosis interface [ interface-type interface-number ] 

Any view 

interface-type interface-number: Interface type and interface number. 

Use the display transceiver diagnosis interface command to display the currently measured value of 

digital diagnosis parameters of a single or all anti-spoofing transceivers customized by H3C. 

# Display the currently measured value of digital diagnosis parameters of the anti-spoofing pluggable 

optical transceiver customized by H3C on interface GigabitEthernet 1/0/25. 

<Sysname> display transceiver diagnosis interface gigabitethernet 1/0/25 

GigabitEthernet1/0/25 transceiver diagnostic information: 

  Current diagnostic parameters: 

    Temp(°C)  Voltage(V)  Bias(mA)  RX power(dBM)  TX power(dBM) 

    36        3.31        6.13      -35.64         -5.19