3com 5500-ei pwr Reference Guide

 

1-1 

display ndp [ interface interface-list ] 

Any view 

interface interface-list: Specifies a port list. You need to provide the interface-list argument in the form 

of { interface-type interface-number [ to interface-type interface-number ] } &<1-10>, where to is used to 

specify a port range, and &<1-10> means that you can provide up to ten port indexes/port index ranges 

for this argument. The interface-number argument is in the format of unit ID/slot number/port number. 

Use the display ndp command to display all NDP configuration and operating information, including 

the global NDP status, the interval to send NDP packets, the holdtime of NDP information, and the NDP 

status and neighbor information on all ports.  

If executed with the interface keyword, the display ndp command will display the NDP status of the 

specified interfaces and the related information of the peer device. If executed without the interface 

keyword, the command will display the global NDP configuration information and the statistics on NDP 

packets received on and sent by each port. 

# Display all NDP configuration and operating information. 

<aaa_0.Sysname> display ndp 

Neighbor Discovery Protocol is enabled. 

Neighbor Discovery Protocol Ver: 1, Hello Timer: 60(s), Aging Timer: 180(s) 

Interface: Ethernet1/0/1 

   Status: Enabled, Pkts Snd: 15835, Pkts Rvd: 2879, Pkts Err: 0 

 

Interface: Ethernet1/0/2