3com 8807 Reference Guide

C

HAPTER

 61: S

YSTEM

 M

AINTENANCE

 C

OMMANDS

User view

all: Enables or disables all the debugging.

timeout interval: Specifies the interval (in minutes) during which the debugging 
all switch is on. The value ranges from 1 to 1440. With this configuration, all 
debugging takes the time at which it is enabled as the start time, and takes effect 
during the predefined time. And after that, all debugging is disabled.

module-name: Module name.

debugging-option: Debugging option.

Use the debugging command to enable the system debugging.

Use the undo debugging command to disable the system debugging.

By default, all the debugging processes are disabled.

The switch provides various kinds of debugging functions for technical support 
personnel and experienced maintenance staff to troubleshoot the network.

Enabling the debugging will generate a large amount of debugging information 
and decrease the system efficiency. Specially, network system may collapse after all 
the debugging is enabled by the debugging all command. So it is not suggested 
to use the debugging all command. It is convenient for the user to disable all the 
debugging with undo debugging all command.

Related command: display debugging.

# Enable IP packet debugging.

<SW8800> debugging ip packet

 

IP packet debugging switch is on. 

The above output shows that the IP packet debugging is enabled.

Any view

None