3com 8807 Reference Guide
RIP Configuration Commands
401
host-route
Syntax
host-route
undo host-route
View
RIP view
Parameter
None
Description
Use the host-route command to control the RIP to accept the host route.
Use the undo host-route command to reject the host route.
By default, RIP accepts the host route.
In some special cases, RIP receives a great number of host routes in the same
network segment. These routes cannot help the path searching much but occupy
a lot of resources. In this case, the undo host-route command can be used to
reject a host route.
network segment. These routes cannot help the path searching much but occupy
a lot of resources. In this case, the undo host-route command can be used to
reject a host route.
Example
# Configure RIP to reject a host route.
[3Com-rip] undo host-route
import-route
Syntax
import-route protocol [ cost value | route-policy route-policy-name ]*
undo import-route protocol
View
RIP view
Parameter
protocol: Specifies the source routing protocol to be imported by RIP. At present,
RIP can import the following routes: direct, bgp, ospf, ospf-ase, ospf-nssa, isis
and static.
RIP can import the following routes: direct, bgp, ospf, ospf-ase, ospf-nssa, isis
and static.
value: Cost value of the route to be imported.
route-policy route-policy-name: Configures to import the route matching the
condition of the specified Route-policy only.
condition of the specified Route-policy only.
Description
Use the import-route command to import the routes of other protocols into RIP.
Use the undo import-route command to cancel the routes imported from other
protocols.
protocols.