3com 8807 Reference Guide

C

HAPTER

 26: I

NTEGRATED

 IS-IS C

ONFIGURATION

 C

OMMANDS

This command is used when you want to reconfigure a certain neighbor.

# Clear the IS-IS neighbor whose system ID is 0000.0c11.1111.

<SW8800> reset isis peer 0000.0c11.1111 

IS-IS view

None

Use the set-overload command to set overload flag for the current router.

Use the undo set-overload command to cancel the overload flag.

By default, no overload flag is set.

If a router is configured with the overload flag, the routes it calculates will be 
ignored by other routers in SPF calculation. (However the directly connected routes 
will not be ignored.) And other routers should not send this router the packets 
which should be forwarded by it.

# Set overload flag on the current router.

[3Com-isis] set-overload 

silent-interface silent-interface-type silent-interface-number

undo silent-interface silent-interface-type silent-interface-number

IS-IS view

silent-interface-type: Specifies the interface type.

silent-interface-number: Specifies the interface number.

Use the silent-interface command to disable a specified interface to transmit 
IS-IS packet.