3com 8807 Reference Guide

C

HAPTER

 42: VPLS C

ONFIGURATION

 C

OMMANDS

Use the pwsignal command to specify a PW signaling protocol for a VSI and enter 
VSI-LDP view.

Specifying LDP as the PW signaling protocol for the VSI takes you to the VSI-LDP 
view.

By default, the VSI uses LDP as the PW signaling protocol.

# Set LDP as the PW signaling protocol for VSI 3Com and enter the VSI-LDP view.

<SW8800> system-view 

 

[SW8800] vsi 3com static

 

[3Com-vsi-3com] pwsignal ldp 

reset mac-address vsi [ vsi-name [ peer peer-ip | vlan-interface vlan-num ] ] { 
static | dynamic | all }

User view

vsi-name: Refer to the configuration of related commands for VSI.

vlan-id: VLAN interface ID.

static: Specifies static MAC addresses.

dynamic: Specifies dynamic MAC addresses.

Use the reset mac-address vsi command to batch remove VPLS MAC addresses. 
The reset mac-address vsi command performs the same function as the undo 
mac-address vsi command does.

Related command: undo mac-address vsi.

# Remove all dynamic VPLS MAC addresses on Vlan-interface10 in VSI VPN1.

<SW8800> reset mac-address vsi vpn1 vlan-interface 10 dynamic 

VSI view