3com 8807 Reference Guide
NQA Configuration Commands
1079
Parameter
max-number: Maximum Number of test operations enabled simultaneously.
Description
Use the nqa-agent max-requests command to set the maximum number of test
operations that can be enabled simultaneously.
operations that can be enabled simultaneously.
Use the undo nqa-agent max-requests command to restore the number of test
operations that can be enabled simultaneously to the default value.
operations that can be enabled simultaneously to the default value.
By default, a maximum of 5 test operations can be enabled simultaneously.
n
If the configured value is smaller than the number of enabled test groups, the
current test is not stopped.
current test is not stopped.
Example
# Configure that the system can enable a maximum of 4 test operations
simultaneously.
simultaneously.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa-agent max-requests 4
probe-failtimes
Syntax
probe-failtimes times
undo probe-failtimes
View
NQA test group view
Parameter
times: Number of times of constant probe failures.
Description
Use the probe-failtimes command to set the number of constant probe failures
after which NQA will send the Trap information to the network management
system.
after which NQA will send the Trap information to the network management
system.
Use the undo probe-failtimes command to restore the number of constant
probe failures after which the Trap information will be sent to the default value.
probe failures after which the Trap information will be sent to the default value.
By default, the system sends the Trap information to the network management
system after one probe fails in an NQA test.
system after one probe fails in an NQA test.
n
The current "probe failures times" will be reset to zero after a test is finished, that
is, this "times" is only valid for a single test and can not cross two tests for
constant statistics. If the probe succeeds, this statistic value is reset to zero too.
is, this "times" is only valid for a single test and can not cross two tests for
constant statistics. If the probe succeeds, this statistic value is reset to zero too.
n
For the concept of test and probe, note the following content: