3com 8807 Reference Guide

command-privilege level level view view command

undo command-privilege view view command

System view

level: Specifies the command level, ranging from 0 to 3.

view: Specifies the command view, which can be any of the views supported by 
the switch.

command: Specifies the command to be configured.

Use the command-privilege level command to configure the priority of the 
specifically command of the specifically view.

Use the undo command-privilege view command to restore the default 
command priority.

The command levels include visit, monitoring, configuration, and management, 
which are identified as 0 through 3 respectively. An administrator assigns 
authorities as per user requirements and allows them to operate in corresponding 
views. When a user logs in to the switch, the command level that it can access 
depends on two points. One is the command level that the user itself can access, 
the other is the set command level of this user interface. If the two levels are 
different, the former will be taken. For example, the command level of VTY 0 user 
interface is 1, however, user Tom has the right to access commands of level 3; if 
Tom logs in from VTY 0 user interface, he can access commands of level 3 and 
lower.

By default, ping, tracert, and telnet are at visit level (0); display and debugging 
are at monitoring level (1); all the configuration commands are at configuration 
level (2); and FTP, TFTP and commands for file system operations are at 
management level (3).