3com 8807 Reference Guide
1
C
OMMAND
L
INE
I
NTERFACE
C
OMMANDS
Command Line
Interface Commands
Interface Commands
command-privilege level
Syntax
command-privilege level level view view command
undo command-privilege view view command
View
System view
Parameter
level: Specifies the command level, ranging from 0 to 3.
view: Specifies the command view, which can be any of the views supported by
the switch.
the switch.
command: Specifies the command to be configured.
Description
Use the command-privilege level command to configure the priority of the
specifically command of the specifically view.
specifically command of the specifically view.
Use the undo command-privilege view command to restore the default
command priority.
command priority.
The command levels include visit, monitoring, configuration, and management,
which are identified as 0 through 3 respectively. An administrator assigns
authorities as per user requirements and allows them to operate in corresponding
views. When a user logs in to the switch, the command level that it can access
depends on two points. One is the command level that the user itself can access,
the other is the set command level of this user interface. If the two levels are
different, the former will be taken. For example, the command level of VTY 0 user
interface is 1, however, user Tom has the right to access commands of level 3; if
Tom logs in from VTY 0 user interface, he can access commands of level 3 and
lower.
which are identified as 0 through 3 respectively. An administrator assigns
authorities as per user requirements and allows them to operate in corresponding
views. When a user logs in to the switch, the command level that it can access
depends on two points. One is the command level that the user itself can access,
the other is the set command level of this user interface. If the two levels are
different, the former will be taken. For example, the command level of VTY 0 user
interface is 1, however, user Tom has the right to access commands of level 3; if
Tom logs in from VTY 0 user interface, he can access commands of level 3 and
lower.
By default, ping, tracert, and telnet are at visit level (0); display and debugging
are at monitoring level (1); all the configuration commands are at configuration
level (2); and FTP, TFTP and commands for file system operations are at
management level (3).
are at monitoring level (1); all the configuration commands are at configuration
level (2); and FTP, TFTP and commands for file system operations are at
management level (3).