3com 8807 Reference Guide
Integrated IS-IS Configuration Commands
465
by searching the nearest L1/L2 router. The nearest L1/L2 router can be found by
searching the ATT bit in the L1 LSP.
searching the ATT bit in the L1 LSP.
This command can be set on L1 router or L2 router. By default, the route is
generated on L2 LSP. If the apply isis level-1 command is executed in route-policy
view, the default route will be generated on L1 LSP. If the apply isis level-2
command is executed in Route-policy view, the default route will be generated on
L2 LSP. If the apply isis level-1-2 command is executed in route-policy view, the
default route will be generated on both L1 LSP and L2 LSP.
generated on L2 LSP. If the apply isis level-1 command is executed in route-policy
view, the default route will be generated on L1 LSP. If the apply isis level-2
command is executed in Route-policy view, the default route will be generated on
L2 LSP. If the apply isis level-1-2 command is executed in route-policy view, the
default route will be generated on both L1 LSP and L2 LSP.
Example
# Set the router to create the default route in the LSP of correspond level.
[3Com-isis] default-route-advertise
display isis interface
Syntax
display isis interface [ verbose ]
View
Any view
Parameter
verbose: If this parameter is used, the details of the interface will be displayed.
Description
Use the display isis interface command to view the information of the enabled
IS-IS interface.
IS-IS interface.
This command displays the information of the enabled IS-IS interface, including
interface name, IP address of the interface, link state of the interface and so on.
Besides displaying all the information shown by the display isis interface
command, the display isis interface verbose command displays such
information about the IS-IS parameters of the interface as CSNP packet broadcast
interval, Hello packet broadcast interval and invalid number of Hello packet.
interface name, IP address of the interface, link state of the interface and so on.
Besides displaying all the information shown by the display isis interface
command, the display isis interface verbose command displays such
information about the IS-IS parameters of the interface as CSNP packet broadcast
interval, Hello packet broadcast interval and invalid number of Hello packet.
Example
# Display the information about the enabled IS-IS interface.
<SW8800> display isis interface
Interface IP Address Id Link.Sta IP.Sta MTU Type DIS
Vlan-interface1 172.16.1.2 001 Up Up 1497 L1 Yes
# Display the details of the IS-IS enabled interface.
<SW8800> display isis interface verbose
Interface IP Address Id Link.Sta IP.Sta MTU Type DIS
Vlan-interface1 172.16.1.2 001 Up Up 1497 L1 Yes
Secondary IP Address :
SNPA Address : 00e0.fc44.5f71
Csnp Interval : L1 10 L2 10
Hello Interval : L1 10 L2 10
Hold Time : L1 30 L2 30
Lsp Interval : 33
Cost : L1 10 L2 10