3com 8807 Reference Guide
632
C
HAPTER
36: PIM C
ONFIGURATION
C
OMMANDS
Example
# Set the time interval to send Hello packets for VLAN-interface10 to 40 seconds.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface vlan-interface 10
[3Com-Vlan-interface10] pim timer hello 40
register-policy
Syntax
register-policy acl-number
undo register-policy
View
PIM view
Parameter
acl-number: Number of IP advanced ACL, defining the rule of filtering the source
and group addresses. The value ranges from 3000 to 3999.
and group addresses. The value ranges from 3000 to 3999.
Description
Use the register-policy command to configure a RP to filter the register messages
sent by the DR (the last-hop router) in the PIM-SM network and to accept the
specified messages only.
sent by the DR (the last-hop router) in the PIM-SM network and to accept the
specified messages only.
Use the undo register-policy command to remove the configured message
filtering.
filtering.
Example
# If the local device is the RP in the network, using the following command can
only accept multicast message register of the source sending multicast address in
the range of 225.1.0.0/16 on network segment 10.10.0.0/16.
only accept multicast message register of the source sending multicast address in
the range of 225.1.0.0/16 on network segment 10.10.0.0/16.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] acl number 3010
[3Com-acl-adv-3010] rule permit ip source 10.10.0.0 0.0.255.255 dest
ination 225.1.0.0 0.0.255.255
[3Com-acl-adv-3010] quit
[SW8800] multicast routing-enable
[SW8800] pim
[3Com-pim] register-policy 3010
reset pim neighbor
Syntax
reset pim neighbor { all | { neighbor-address | interface interface-type
interface-number } * }
interface-number } * }
View
User view
Parameter
all: All PIM neighbors