3com 8807 User Guide

Page of 883
190
C
HAPTER
 22: Q
O
S C
ONFIGURATION
By default, the switch obtains local precedence and drop precedence according to 
the default mapping values.
Configuring default local precedence
Perform the following configurations in Ethernet port view.
Perform the following configuration in port group view.
Configuring Traffic 
Policing
Traffic policing refers to rate limit based on traffic. If the traffic threshold is 
exceeded, corresponding measures will be taken, for example, dropping the 
excessive packets or re-defining their priority levels.
In the traffic supervision action, the switch uses the service parameters allocated 
according to the DSCP + Conform-Level -> Service parameter mapping table and 
the EXP + Conform-Level -> Service parameter mapping table and the 802.1p 
priority values allocated according to the Local-precedence+Conform-Level -> 
802.1p priority mapping table. So you should configure these three mapping 
tables or use their default values.
Configuring mapping tables
Perform the following configurations in the specified views.
Configure the CoS -> Local-precedence 
mapping table 
qos cos-local-precedence-map 
cos0-map-local-prec cos1-map-local-prec 
cos2-map-local-prec cos3-map-local-prec 
cos4-map-local-prec cos5-map-local-prec 
cos6-map-local-prec cos7-map-local-prec 
Restore the default values of CoS -> 
Local-precedence mapping table 
undo qos cos-local-precedence-map
Table 160   Configure default local precedence for port
Operation 
Command 
Configure default local precedence for a port  priority priority-level 
Restore the default local precedence for a port  undo priority
Table 161   Configure priority for the port group
Operation 
Command 
Configure local priority for the port group 
priority { priority-level | trust } 
Restore the local priority of the port group to 
the default value 
undo priority
Table 159   Configure mapping tables
Operation Command 
Table 162   Configure mapping table
Operation 
Command 
Enter conform level view (System view) 
qos conform-level conform-level-value 
Configure the DSCP + Conform-Level -> 
Service parameters mapping table (conform 
level view) 
dscp dscp-list : dscp-value exp-value cos-value 
local-precedence-value drop-precedence